![]() The base station password is set to "public" and the IP address is reset. The middle LED will flash once a second while the device is in soft reset mode. Hold down the reset button for 1 second.Locate the reset button on the base station, next to the ports. When instructed to do so, press this button with a pen or straightened paper clip. If you're using an AirPort Graphite or AirPort Snow (Dual Ethernet) base station, connect your computer directly to the base station using an Ethernet cable. You can then use AirPort Utility to reconfigure the base station. Wait about a minute for the base station to finish restarting.While holding down the reset button, connect the base station to power and continue to hold the reset button for about 6 seconds, until the status light on the base station flashes amber rapidly.Disconnect the base station from power.When AirPort Utility indicates that setup is complete, click Done.įactory default reset, available only with firmware version 7.9.1 on AirPort Time Capsule 802.11ac and AirPort Extreme 802.11ac:.Click ”Restore previous settings”, then click Next until you get to the final window.Click the Other Wi-Fi Devices button, then select your base station from the list.Press and hold the reset button for about 5 seconds, until the status light on the base station flashes amber rapidly.You can now change the password or reconfigure the base station as needed. Click the icon for your base station in AirPort Utility, then click Edit from the pop-up menu.Open AirPort Utility, which is in the Utilities folder of your Applications folder.From the Wi-Fi status menu in the menu bar, choose the Wi-Fi network created by your base station.The status light on the base station flashes amber. Press and hold the reset button for 1 second, then release the button.Make sure the base station is connected to power.When instructed to do so, press this button with a pen or straightened paper clip. ![]() Locate the reset button on the base station, next to the ports. You can then use the device in its default state or reconfigure it using AirPort Utility.īefore resetting your base station, it's best to make sure that its firmware is up to date, if possible.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |